motor casing stamping solution-zigzag feeder and 3D transfer system

The material roll is uncoiled and levelled by the uncoiler and leveller 2 in 1, and then feed to mould by the zigzag feeder. The middle conveyor receives the material from the 1st punch and transfers it to the next punch by 3D transfer manipulator. Manipulator works with the punch to complete the product by 12 steps process, such as blanking, drawing, and finally the product is sent out by the conveyor belt. Because the speed of the front and back presses cannot be completely unified, this production line focuses on the control and structure of the synchronization between the two presses.

Product name: motor casing
Thickness: 0.4-3.0mm
Coil width:400mm(MAX.)
Left and right swing speed: 30m/min. (MAX.)
Front and back feeding speed: 16m/min(MAX.)
Clamping stroke:0-300mm
Transfer stroke: 0-400mm
Lifting stroke:0-100mm

Line configuration:

1, UL uncoiler leveller 2 in 1
2, NCZRF zigzag feeder
3, 3D transfer manipulator
4, Magnetic conveyor belt